Nwda Je Civil best 30 Questions Quiz -7

1.Which of the following is incorrect about the minimum size of a single run fillet weldA. it should be 3 mm for thickness up to and including 10mmB. it should be 5mm for thickness between 11mm to 20mmC. it should be 6 mm for thickness between 21mm to 32mmD. none of the above.Answer :- it should be 10 mm for thickness between 32mm to 50mm. so all option are correct none of the these options is incorrect. 2.The yield stress and the ultimate tensile stress for a greater than 16 mm diameter Bolt of grade 8.8 Steel in MPa will

The post Nwda Je Civil best 30 Questions Quiz -7 appeared first on Exam Guru g.



from WordPress https://ift.tt/3oBStZ7
via IFTTT

Comments

Post a Comment

Popular posts from this blog

Civil Engineering || HPGK || Previous Years Questions

  1.A type of door used to supplement the natural lighting provided by window is known as___________. A. ledged door B. panelled door C. glazed door D. braced door Correct Answer: Option 3  1.Glazed Door: – This type of door is made with glass panels and can be fabricated to a particular shape and pattern. It is used to supplement the natural lighting provided by the window Use: Inside the house where there is an architectural and aesthetic requirement. 2.Braced Door: – Braced doors are wooden strong and sturdy doors made of at least three horizontal and one diagonal rail on the rear side of the door. Use: In barns, garages, and sheds, etc. 3.Frame and panel: – Consists of a framework of vertical members called styles and horizontal members called rails. The panel is made from timber, plywood, and blockboard. Use: Almost used in all type of buildings. 2.Concrete corridor is made if daily traffic is not more than ? A. 500 ton B. 750 ton C. 1000 ton D. 1250 ton...
Read more

All india level Je/AE Questions Quiz- 6

1.The percentage of earnest money isA. 1%B. 2%C. 5%D. 10%Answer :- While submitting a tender the contractor is to deposit a certain amount, approximately about 2% of the estimated cost with the department as the guarantee of the tender is called as earnest money. 2.The percentage of security money is aboutA. 2%B. 5%C. 10%D. 15%Answer :- If the contractor accepted the tender , then he has to deposit 10% of tendered amount as security money with the department which is inclusive of the earnest money already deposited. 3.The unit of measurement of supply of coal isA. Cubic metresB. Sq m.C. The post All india level Je/AE Questions Quiz- 6 appeared first on Exam Guru g . from WordPress https://ift.tt/344Frd2 via IFTTT
Read more